Recent content by ihtiyar

Thanks chock, I have repaired the defective cards with the robust card on the new machine. Dolev V2 runs smoothly. I also had backup cards like OMC + strobe7 + CRI. [email protected]

Hello, Thank you for your attention. I got a new Dolev 800 v2. Problem is solved. The defective dolev was spare parts.

Reset did not work.

Dear chock Thank you for your interest. But I'm not a technician, my user. I've done cleaning and checking as much as I can. The result has not changed. But I did not understand the RESET phenomenon. Can you give a little more detail?

I have not seen the place I have not looked at for 2 months. I need to get help from outside. Thanks for your interest...

Thank you Scotts, but I cleaned my card and even cleaned it with the Electronics Technician, but there was no solution. Dolev is still not open. Electronics technician says no fault. I was desperate.

1. I can not enter Diagnostic. Tools Operations does not open because Dolev is not Standby. 2. No Diagnostic diskette?

please, can you explain some more, picture or otherwise? plase, plase...

abort-status-parms-util does not work because I am not in standby, but I will try again. Any other suggestions? NOTE: I can not intervene because there is no fatal error.

I cleaned it with an eraser. The error did not change. Do you have any other suggestions?

I clean it with air and put it back on. The result has not changed.

Hello, The machine is booting up OMC: Program Load Error. I'm glad you helped me. Thank you...