Recent content by james_aug

hi where u from i need help on repairing heads.. th 1.7 and th 2

pl share me ctp model and details..

what is the error messahe shown

let me know the error code

did u get thru..??

hi i have few thermal heads th1.x and th2.5.. let me know

i guess no need to worry...unless other wise you r catering to market leaders.. still i know evo 3.3 and 4.1 beeing used in current updated design softwares.. still going well.. may be u have a extra work of getting your job done well for prepress..

has it been looked in to and solved..? if not pl reach me here

hi still u have this verion or any updated one...?? let me know details

head cover opened and cleaned all mirror and glv and cover till the beam sensor.. a few times but no improvements.. blower and sucker mouths and tubes have been removed and cleaned,, pumps are working fine..

hi at 110k plate count laser bandings are seen... how do set up beam balance and rpm..

hi how to change exposing rpm in screen 8800III.,.,and set it up.. at user maintenance it is not happening error e6e6d shown.

sure.,., i am profnl... i am playing with both machine and both r av44.. not 44s.. let me start over again.,.,.with more patience...

hi Farshad, thank u for the reply.,., let me explain, it is avantra 44, what i replaced is from currently working 2nd machine (avantra 44).,., and i made sure these 2 machines run with same firmware by re-programming the first machine to suit 2nd one suitable firmware updates..(boards are...

hi thank u fore the reply,., i failed to mention that i had tried all flat ribbon cable(3 Of it), smps and touch pannel too from working machine.,., every part is working with similar machine.,., from A machine (problematic) all boards cables smps work with B machine from B machine same problem...