Recent content by KROMATICO

Hello, sorry I have pasted the part to be translated, not the translated one

Buongiorno, ho aggiornato il mio XPO da 3.1 a 3.5 e mi da problemi con il lotem 800 da errore 4 di XPO e il lotem da errore da parte dell'hosts il server è un dell 840 con win server 2003 a 32 bit da cosa può dipendere?

Good evening, I have a lotem 800 with xpo 3.1 I switched to xpo 3.5.0.61 working on a dell 840 the hard disk is an ssd gives me this error: -4 xpo error and does not affect the plate on lotem the message is: expose task aborted by host Depends on what?

Thanks, now check if there are small pieces of paper or other, thanks again

Hello, I have a Lotem 800 and I have problems with the alignment of the sheets in four colors, I tried to lock the drawer of the slabs, align the y axis where the suction cups but nothing is ever out of register, any suggestions?

Thanks for the advice, it was easy

hello, I have a Lotem 800 and I have to replace the suction cups that take the plates, I had suggested with the Allen key but mine is an older model and is removed in another way, can anyone help? Thank You

Hello, then I proceed by trial and error? and after the single diode as an individual? P.S. thank you for the time I spend

Hello, I have a Lotem 8oo with 48 laser diodes and maybe a diode is damaged, how do I know which one?

Hi, some days it is very hot and I turned on the air conditioning, but I get this same error message: "Pre laser calibration (expose mode) tec unit temperatures fail!" the plate is not engraved, and then the machine locks up! But last year with the same temperature as the machine is blocked what...

da 33 a 36

The time now is operating normally! What can be?

I turned on the Lotem 800 and again tells me the same diode, how do I attach the diodes neighbors? To make a plate 370x510 takes about 25 minutes!

laserhead machine 48

Hello, today happened to me a serious problem, my Lotem 800 tells me that four laser "non-working" and performance will be reduced. Is there a way to reset or check if the diodes are broken? They told me arrange it cost 1.400,00 euro each (excluding surgery), but these are the prices? I seem too...