Recent content by ksm1701

Thanks for the reply Andrew. It was a one-in-a-million problem that everyone here on the Pre-Press side of things could see was down to whoever designed the job, unfortunately though, the higher-ups wanted to find a magic bullet to spot the issue the next time it pops up (presumably after the...

Hi guys, Usually I would be able to find somebody else's similar problem and amend the Action List to do what I need, but in this instance I'm really struggling trying to work out how to set an action to do what I want. Basically, we have had a customer supplied PDF that had layers upon layers...

Thanks Andrew. I have now logged a case within the support Portal.

Hi all - hope somebody can help with this as it's driving me mad! After preflighting in XMF I like to see what errors have been picked up so right click on the PDF and then select 'Open preflight report with document' which then opens the preflight report with the document PDF in the...

Thanks for all the replies. Finally bit the bullet and installed DC and then Pitstop 2020 - and DC now crashes at launch so now need to do some investigating. Mondays - yay :p

I've been dragging my heels over moving to Acrobat DC for years now due to the unappealing UI in comparison to Acrobat Pro XI. Now with the release of Pitstop Pro 2020 it looks as if I finally might have to make the switch. Anyone else in a similar boat or does anybody have any tips on how to...

As mentioned above, take a look at Prinect, Apogee, Prinergy and Switch as potential solutions, but run for the hills if anyone mentions Fuji XMF!

Thanks for the helpful replies guys. :) I'll try the alternate PPD option and if that doesn't work I'll take a look at the film input sensor.

Hi everyone, hope somebody can help. We are running a Dolev 450 with PS/M RIP 6.1 and just recently it has started to output film oversize (almost square at 26" x 26" / 660mm x 660mm). It doesn't matter what we enter the output size as when printing to the PS/M, the film always comes out of...