This was happening before....after phone support with EFI...either a bad damper or a float switch.
switched floats with another channel....and put new dampers on all 3 ch 5 heads...heads kept clogging- ordered new heads.
got new heads in, printed great for a few hours....then got crappy...
put 3 new heads in for Mag. if voltage is set where the head says it should- i get overspray. had it set about 1.5 volts under and printed 15 sets of 4x8 no issue... now printing these- this is 3up on a 4x8...seems like Mag is dropping out by end...pics are in reverse order of how they printed...
Automatically Autonomous Automation
Although the autonomous car is not quite ready, a lights out print operation is something you can do right now if you have a comprehensive Print MIS (Management Information System). The advantages can put money on your bottom line. So what’s your next step?
Link to Article