Recent content by leecott

We run a lot of labels through our 1060 and initially had similar problems with curling and corners creasing. Grain direction as mentioned was 100% the issue for us. If you are feeding from draw 1 or 2 we would recommend having the labels face down. You may find the creasing is coming from the...

We're currently running SRA4 sheets through the cutter, our margins are setup as 8mm and had no problems at all - you just need to ensure the margins are set the same in Illustrator (or Coral Draw if thats what you use) and in CCP - i can provide a screenshot of our setting in CCP if that would...

Been running mine since Monday - unfortunately as it stands mine is due to be swapped / out exchanged. Getting it setup, seemed simple enough until you actually attempt to scan a QR code or manually enter the cutter number. Maybe it's just me but I found there was not much information on how to...

I did bite the bullet last thursday and took delivery on Monday. Like yours it's still sat in the crate, and will be until the weekend. Downside of the LC600 was needing to purchase a PC for the colourcut Pro as we're completely mac based - this won't arrive till Friday. Our KM is also on a...

This was from Intec direct - i am based in the UK. The price wasn't discounted specifically for me - i just enquired about the price and they sent the list price along wit the October promotional price. I then asked if they would include the stand. I can only assume the price is higher outside...

Have you got the LC600 up and running yet? If so whats your thoughts? I'm in a very similar position as you were, I cannot decide between a label printer or going with the LC600. Intec are currently doing the cutter for £2,999.00 (October promotion) plus they said they could include the stand...