Recent content by lilprint

  1. L

    The Big Job was Going Great Until…

    Brush plating sounds like a viable alternative to spray welding. Thanks for such an informative article.
  2. L

    KBA 162a Plate slipping out of back clamp

    1) Either something is stuck in the plate clamps not allowing it to fully close. 2) A clamp spring is broken inside the cylinder. 3)or the most likely is that the form roller pressure is to heavy and its pulling the plate out.
  3. L

    Print quality problem on a Heidelberg Quick Master running #10 envelopes

    Confirmed. That looks like the culprit. :) Thanks
  4. L

    Print quality problem on a Heidelberg Quick Master running #10 envelopes

    I have an interesting problem that appeared on a Heidelberg Quick Master running #10 envelopes. The black letters of the type on the top envelope have a shadow image behind the W. The top envelope is a side seam peel and seal with a 20pt caliper under the W were the flap, seam and front stock...

What About Profitability?

Canon
What about Profitability?
Offset yields new advantages

Read All About It

 
Top