Recent content by Risu

HP inkjet press

Print plates pure black. Those dots are security dots, printed on yellow, hard to see on naked eye.

I'll do all services for my Konica C6500-7000 series. Parts, consumables and repairing tips easily available. Affordable to print also.

Heidelberg DI offset, 10-20k $

A quite strong comment thg. What kind of paper/manufacturer/type did you use? How was your machine serviced?

Konica C5500-5501 with super low clicks something like 100.000-250.000. Konica C7000 ​​​​​Seal laminators, different sizes Polar EM76 quillotine Summa 160d plotter/cutter Neopost envelope/inserter line

Search "flatbed uv"

Older laptop, perhaps with docking station...

How about brown eggs? :p

Hi Neilprints, please check PM

[On a serious note, Do you really think that we can print with just H2O, no additives, on continuous feed dampening? Some polyplates works just fine with 100% H2O

Clean relays contacts with sandpaper etc. I did so about four years ago and problems solved so far.

There is a few relays on the electric board, on the front right side. Open relays plastic cover and clean the relays contacts. I did it once when I had positions problems and problem solved.

If the wire is broken, machine lose position most of the time in the same position. When it loses positions, then try to move the cable to other position as a first aid.

Under the table locate grey wire which goes to the saddle. When saddle moves back and forth many times the wire will break. Breaking point is probably near of the wire´s connector.