Recent content by tekcontrol

Thanks, for your help, I'll try it.

An Agfa LP 82 Ultra lithostar has permanently error Water Pressure low, any ideas about the problem?

What kind of problem do you have? Maybe I could help you.

An Avantra 30 gives the error 149 during booting, the spinner rotates for a few seconds then stops and the Avantra shows that error. Custormer reports he also see errors 135, 183 and 149, as well as 17 when printing. How could Isolate the problem between Spinner, Dec Board, or other board...

I've an Agfa Accuset 1200 with and Agfa Star 600 Rip, it's working fine but I need to calibrate it (grayscale ). Because these imagesetter does not come with any manuals or software I try it using Agfa Calibrator (v 4.0 and 4.01) for Macintosh, but I receive only postscript errors and the...

The Taipan Rip is seeing the Accuset Imagesetter

Yes the Network Cable is connected, and I could see other machines over the network

Vlad, the Rip is connected to a Accuset 1000, I'm tryin to run Agfaset from the same RIP computer

I install from zero an Agfa Apogee Taipan 3.01 on a windows NT computer. The installation has no errors, but when I open Agfaset it keeps me showing the message "Select Printer" and nothing to select. All the inputs are enable at the Taipan Tuner. The network at the windows NT is working ok. Any...

I've several jams at the Avantra 30E bridge, the film goes well into the first bridge rollers, but some how the cut does not complete and I get a Jam error. The cutter is working good because if the bridge is open it cuts well 100% times. I notice the plate shown at the picture is doing...

I'll check spun motor , but I don't know where and how adjust BOL data, could you give me a hand on that?

Yes, the spinner was replaced more than a year ago.

I follow Vlad suggestions filming a black page and the result inspecting the laser beam is that the image is printing outside the film area, part of laser is heating the top metal parts of the drum and some part of the film is not being exposed by the laser, it is like the whole printing area...

At an Agfa Selectset 7000 portion of image missing. Suddenly, without any errors, part of the image, across the film output is missing, there are about 3 inches that do not appear on every large print, it doe not matter which film width is using, every image that uses about the whole drum...

That's why we're called third world, the old train is still running.