Search results

  1. T

    MAKO46 Imaging issue

    Picture A looks like it may be spinner motor encoder, cleaning the encoder should solve the problem. But has something else gone wrong to produce the results in pictures B and C
  2. T

    Avantra 44s Cutter not working.

    Most likely the cutter switch. If the miniature slide inside the switch is worn or dirty the electrical contact is not switching cleanly or fast enough
  3. T

    aperature jam

    There’s a one way bearing in the center of the appeture disc it has possibly dried out does the disc rotate easily in both directions? there should some resistance in one direction only, the bearing may need a drop of lubrication
  4. T

    bypass for processor not ready

    Go to utilities menu, switch to offline icon it won’t look for a processor, but it will look for a daylight cassette
  5. T

    bypass for processor not ready

    If error 27 is flashing, try switching off the processor for one full minute then switch processor on. This will work if it is a temperature issue
  6. T

    Agfa VCF 85 User Guide and Service Manual

    05 wait = level low on gum bath. is fill pump constantly running But not drawing up chemical?
  7. T

    Onyx 700 processor repair

    Where is this machine located?
  8. T

    Mitsubshi Echo 1630 III

    Cheat door switch,shine flashlight into right hand side of Rack,run another prefeed or a real job, you should see activator raining down from spray bar? (3 jets) if not,this in the problem
  9. T

    Mitsubshi Echo 1630 III

    Did you do another prefeed? Any trace of silver?
  10. T

    Mitsubshi Echo 1630 III

    Hi What color is the plate? Black = fogged Silver=no exposure Purple=no activator from spray bar
  11. T

    Epson 9800 not powering up after head clean

    Reseat flat ribbon cable on control panel,it might have been partially dislodged when refitting cover
  12. T

    Vertical Black Lines issue with Accuset

    your problem is with the spin motor, dirty encoder most likely causing lines, dirty optics are affecting exposure spin motor requires agfa service engineer. i am too far from scotland
  13. T

    Agfa Rapiline 66 won't slow down

    As far as i can remember there is a magnet and a reed switch on the drive gear on the motor, perhaps the reed switch was knocked out of position and not sending back pulses to board, it counts the revolutions of the gear and controls speed,
  14. T

    Avantra 25 Low Density in half page

    i came across similar density issues on avantra 25 many years ago it was the Velcro strip dangling and moving in front of spin motor
  15. T

    avantra 25 door open error

    looks like you now have a seperate fault,was the cpu powered down for more than two days?try to gently heat cpu board with hairdryer while powered up,it might boot up,
  16. T

    Avantra 30 Frecuently Error 55 and 53

    error 53,55 error 53,55 check to see if bridge rollers rotate freely in one direction only. if they rotate freely both ways problem with oneway bearing, is there any condensation in input section of processor? if yes check scavenger fan.
  17. T

    avantra 25 door open error

    look for bridge rectifier on relay board it may be open circuit it provides 12v dc to cooling fan and scavenger fan and door circuit are these fans running? if not, it is the bridge rectifier.

PressWise

A 30-day Fix for Managed Chaos

As any print professional knows, printing can be managed chaos. Software that solves multiple problems and provides measurable and monetizable value has a direct impact on the bottom-line.

“We reduced order entry costs by about 40%.” Significant savings in a shop that turns about 500 jobs a month.


Learn how…….

 
Back
Top