Search results

Hi, i have some of them from Duplo. Send me email, please Let me know, sincerely Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

Please identify why type of Technotran do you have ? if you take some PIC from ID from the plate of Technotran for help you, in the troubleshooting Let me know, sincerely Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

send me your email Blessing

Service and Maintenance complete Multilith Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

Hi sir I have some tech documentation for Multilitih Let me know, Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

Hi sir: I can quotate from Other place from Malta if you want send me :1) model 2) parts number 3) serial number 4) delivery country 5) quantity Blessing [email protected] Cell+WhatsApp:+505 8861 1441

Hi sir: Hi sir: Look for error 03 1) Dampening solution supply interrupted 2)Dampening solution connector Not properly connected 3)Supply pressure too low 4)Level sensor dirty 5)Lever sensor defective Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

Sir you can NOT configure , if you first does Not fix the power problem. Please do it, after that you can do it. i will instruct it. Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

Hi sir: 1) you must Tight all the power Inputs cables+wires for Feeding machine 2) Tight the wires power Primary to the main transformer 3) tight the power wires secondary of the main transformer of the machine. 4) Test the main switch of the machine, can be fault, by the contacts : a) dirty...

ok sir. Thank you in advance, sincerely Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

I have others Models, but Not that you are looking for However is the same system, for troubleshooting, as I did indicated Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

Hi sir: Please test : 1) Fuse or circuit breaker . 2) The switch of Powder Unit . 3) if are o.k measure the Transformer primary and secondary Voltages if are o.k???? 4) if are o.k mesure the Rectifier Bridge if the output is o.k againt the Schematic Diagrams. 5) Look for loose wires, or...

Good sir Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

If you need tech documentation i can supply [email protected] Mobile+WhatsApp:+505 8861 1441

Hi sir: Attached is there the manual from Polar: Cutting in Practice Hope you enjoy it [email protected] Mobile+WhatsApp:+505 8861 1441

Hi sir: Normally any equipment, the indicating Led, is only sign for to notify the process is End. Not for to indicate to Turn Off the machine, that is Not normally in any machine process. Will be a possible, the some electronic boards( like Laser board)+ specifically the Power supply that...

Hi sir: Let me know, what is the problem ?? In order to help you Blessing [email protected] Mobile+WhatsaApp:+505 8861 1441

Hi: Atached is there some video for set up Blessing [email protected] Mobile+WhatsApp:+505 8861 1441

Finally did you test the power supply? See the schematic diagrams, what cptronic do you have ? Let me know. Blessing [email protected] Mobile+WhatsApp:+505 8861 1441 Let me know, sincerely

Hi sir; I saw your problem. When you replace the hydraulic oil, you must Bleed the entire system, otherwise the paper cutter will Not o.k Bleed: 1) clamp 2) cluth , and see if the machine are NOT leaking in some please. All solenoids must be clean, and look for any oil coming, see for...