Search results

Drupa is earning profit by selling more and more space to Benny in every exhibition since it's introduction.

Have you checked the skew setting of the pan roller? Also the pan roller comes with crowning, make sure the pan roller is according to specs. Try running with intermediate Z roller off from inking roller and see if you get better results. Conductivity is high assuming you are running with IPA...

For exterior you can use waste stripper from BOBST or some Chinese manufacturers also produce waste strippers. Saves a lot of time. For interior you can do it on die cutters.

It's because of the inking system difference on both models, Anicolor is a great system but in terms of maintenance costs it is more expensive to maintain. Also with anilox type inking system you need to set different screening parameters than the conventional.

Just made a video for fun. It's a 2400 dpi, 150 lpi square dot screen. ​​​​​​ ​​​​​

May be you can call a Heidelberg demonstrator and ask him to give you some training on this press.

Joggers move away when sheet is being delivered and then move in.

I don't have any experience of XL but as a rule of thumb, always use the minimum air settings when printing lighter or thinner stocks. If all air settings you believe are ok then also check your delivery gripper settings to make sure all are at same settings. As far as set-off is concerned...

Try to restart your computer as many times as possible, hopefully this will resolve your problem.

You can also try ImpactCad 2016, this software is specially designed for creating boxes.

Why not a GTO?

QM46 DI or conventional?

As far as Cron, their remote assistance is superb and you can get technical assistance 24 hours.

I don't agree with you pauly92, it is not necessary that one should know everything.

For GTO it should be 4 mm to vibrator/oscillator roller and 3 mm to plate for 1st and 2nd form roller, 2mm for 3rd and 4th roller. See the attached file, I hope this helps. Regards

Which press is this?

I had to install Instagram again.:( Now I'm following you. ;)

You need to measure Shore A hardness, if it is near 35-40, its time to change the rollers. There are many other signs of worn out rollers like, Cracks on roller surface, size of the rollers below specs and tolerances, roller not of same size on entire width of the roller (mostly diameter gets...

We deliver the best print quality (we're able to produce), at the lowest price (you're not willing to pay)

I have cleaned many presses before installation and paint remover works best for dried ink.