Search results

We have changed - replaced the developer. But the problem is still there.

HI, WE HAVE LUXEL VX9600 WITH CELEBRANT WORKFLOW. SUDDENLY WE ARE FACING A BANDINGS WHEN OUTPUTING PLATES. WE ARE USING FUJI LP-NV PLATES. THE PLATE SCANNED IMAGES ARE ARE ALSO ATTACHED KINDLY ADVICE. WE HAVE REINSTALLED THE WORKFLOW SYSTEM. BUT THE PROBLEM IS NOT SOLVED. PLEASE ADVICE. I HAVE...

Thanks, dear for your prompt reply it is very helpful for us and now i have restored our database. Thanks Again.

Hi, Our Celebrant workflow crashed and we have reinstall the software. Now we need to restore our database from the backup files we have saved earlier. The Database utility software is running but the RESTORE option is not activated (grayed). Kindly guide us how to restore our database. Thanks

Dear Guys I have managed this issue, we have to sync the cassette numbers with the Rip, and also have to define two devices as per cassette. Regards Adnan

Dear Guys, We are facing the following issue: "we have installed Torrent Rip ver 5 (Torrent 5.5r1c), setup the device i.e. Agfa Avantra, make a uncalibrated cal but when we release the job for output the error "Cassette 0 not available on Spindle A or B" comes in teh message window and jop...

Avantra 25s and Torrent Rip with HW 776.

Guys, Facing Issue with Interpage Gap settings, default it is 1.5 inch, set it to 0.5 inch, some jobs imaged OK with the 0.5 inch gap, but some separations overlaps each other (no gap or to minimum gap) Any suggestions or remedies.

Dear guys, Pls. Suggest, Is it good to put the spinner sleep settings on Avantras.? Pls. Advice.

Hi, We are using Express RIP Ver 8 with Selectset 5000, in the RIP Messages windows we are getting "ERROR IN CONFIG FILE" message continuously, also when we release the job for imaging the imagesetter forward the film of about 3ft (36"). we select the "Select Set 5000 LR" machine in Device...

Can we make complete color chart file from this. if yes pls. guide for the values Thankyou

Dear Guys, Are there any possibility to repair Highwater Interface Card? Kindly advice

Dear Sir, We are now facing the following issue kindly advice: "The machine boots up normal, but when we run the machine test the system hangs and motherboard LEDs starts running upside down and carriage also not moving" Kindly advice and suggest.

ss5000 ss5000 Dear guys, we are facing the same issue in ss5000, the machine boots up normally but when we run the machine test the machine hangs up and carriage also not move, and no laser visible too, in the diagnostics the beam shows up [when system ask to turn on the beam] kindly advice.

Mr. Akbar Pls. provide your contact info? I need to talk to you for the support, I am in Karachi, my cell no. is 0321 2516610 Thanks

Dear farshad, Thanks for the support, can i have a contact of Mr. Akbar Khan.?

Dear guys, pls.. suggest remedy...i am dependent on this equipment. Thanks a lot Best regards

Dear guys, We are facing the BLANK screen issue on our SS5000, the scenario is as below; "We are imaging our jobs normally and suddenly the RIP and Machine hang up :( we restart the imagesetter and the RIP but the imagesetter OCP is blank while the status LEDs on the motherboard (qty:08) are...

Dear Tek, please do check your private message. regards Adnan

Also be sure that you have properly installed the Sentinel Driver. Also just plug in the dongle at LPT port and do not connect anything else. Regards