Search results

The orange roller of my Astro Amc-2000/AbDick envelopfeeder seems to be to smooth. Does anybody has some ideas how to increase the friction on this roller?

I was affraid it could be a costly fix. thanks pdan

Thanks for trying to help. I allways use the wash-up trays for the same unit (I've marked them 1 and 2). I also check the rubber blades, that they pick up fluid evenly. But the problem is more localy and with the form-rollers (ink not cleaned off at ±2cm), so there's not enough pressure at some...

Not all my rollers on my Ryobi 3302M or completely clean after washing, altough the pressure of the rollers is set to max. Did someone have the same problem?

I finaly know that it's the speed control that caused this. If I only knew this sooner ;)

Hello, thanks for the website, but there's no info about troubleshooting this conveyor. It looks like an electronic problem to me, so do you think I have to replace the whole PC board? How would you solve this?

I have an Astro 100 conveyor delivery that I use on a Ryobi 3302 for envelopes. It worked fine for years, until now. It simply stops working after some time. The time it does work depends on how long it was off. So after a few days of not working it works about 40 min., it than stops, so I turn...

I guess not many people use this (because of the low reply), alltough it's a pretty good solution. I've had this done by a technician. But I still would like to share some ideas with people who use this. Thanks Johu

I would like to clean the mirror(s) of my digiplater mitsubishi sdp-eco II. Can someone give me some advice on that?

Thanks Tomtech for your reply, I just want to have a better knowledge of how these machines work, so every documentation is interesting for me. I'll keep looking on the net.

Hello, I have an old ABDICK 9810, that needs some repairing sometimes, so I could use a repair manual for this machine. I'm also looking for a repair manual for a Heidelberg GTO46. Do these manuals exist as pdf? If somebody has a printed one, I would pay for scanning it. There are also some...

When I turn on my ABDick envelopfeeder I get a strong zooming noise en it feeds continualy. Anybody else experienced this? What part of the machine needs replacement? Also I'm looking for a supplier of ABDick/Ryobi parts in Britain. Greetings

Thanks again to all. It has been very interesting for me. I need some time to try out all this advice, but I'm sure I can make it run better now. Regards Chris

Yes, if the stop fingers are lowered to the ultimate position the envelop will not be alligned right (crooked/skewed text and wrinkled envelop). By the way, when printing small envelopes (with front-windows) on the back (flap) the edge of the windows also can get teared. I solved this by...

That means my Heidelberg GTO has head stops. Thanks Al for the comprehensive explanation.

I tought stop fingers and head stops where the same thing, but I have to learn a lot about the parts of the machine. I have the adhesive rubber blanket so I'll use that. Thanks

Sorry, I meant: on the "cam"-wheel on the outer right side. I'm not so sure how tick this tape should be. Chris

I did'nt realise it was the head stops causing this. Hopefully I can adjust it far enough to solve this. Al Ferrari, if I understand it, you stick a piece of tape on the "cam"-wheel on the outer left side, above where there is already a bump on that wheel. This cam wheel pushes the upper feed...

Printing large envelopes on Ryobi 3302M The 9x12inch envelopes snag/tear on the underside, because the seams are not glued well enough and hook behind a machine part. Maybe the guides near the paperfeed-drum causes this. I saw that Richard had the same problem. He mentioned that the guides can...