Azura C95 – gum not pumping into processor

Hi everyone,

I cleaned the filter on the Agfa Azura C95 Processor. When I put everything back together and restarted the processor I kept getting an error "03 no gum"
although the gum was 2/3 full. However the gum was not moving at all. I replaced the gum with a full 20l bottle of water to clean the processor, no "03" error this
time but it is not being pumped at all. Is there any way I can fix this?

Thanks in advance.
 

maxon

Well-known member
Hi there check fuses F1 and F2. Check wiring going to gum level sensor in the external container, broken wire or cable chaffed.
 
Hello folks. I had a solution to the problem. I checked the fuse, the valve was closed, still not working. Nothing was even coming out the filter. I checked the filter however, the filter had been put in at angle so it was damaged. The engineer came in to have a look, it turns out fragments of the filter were stuck in the pipes. He cleared It so everything working again. If you have a problem like this check your filter. Once again thanks for your help.
 

What About Profitability?

Canon
What about Profitability?
Offset yields new advantages

Read All About It

   
Top