padrao
Well-known member
Hello to everyone .
I have one strange problem with this plates to print on Sthocastic screen .
The proble is the density of the ink is getting high, during the printing , i have do stop the machine Komori 4 colors , clean the plate 200 sheets more stop clean . . .
With conventional screen o don´t notice this problem, the RIp as dot Gain control for Sthoscastic .
The printing result is good but why the ink density change ?? I always try to start with low ink, when i get the ok sheed, i only can print 200 sheets ok , because the density is getting higher and higher .
The Rip is Metadimension 6, CTP Suprasetter 74 .
Any ideas will be welcome .
Best Regards
Jorge Azevedo
I have one strange problem with this plates to print on Sthocastic screen .
The proble is the density of the ink is getting high, during the printing , i have do stop the machine Komori 4 colors , clean the plate 200 sheets more stop clean . . .
With conventional screen o don´t notice this problem, the RIp as dot Gain control for Sthoscastic .
The printing result is good but why the ink density change ?? I always try to start with low ink, when i get the ok sheed, i only can print 200 sheets ok , because the density is getting higher and higher .
The Rip is Metadimension 6, CTP Suprasetter 74 .
Any ideas will be welcome .
Best Regards
Jorge Azevedo