Recent content by mrozin

Hello! "error E0e01:Excessive current." it was a pair of two cables black and brown. From 807 on the head. lines is another problem. The problem is in the data cable. Damage in cable, because it always moves. I had many problems with moving cables. Good luck!

No errors. Working fine. I know about alignment procedure, but i didn't do it myself. I think i will have a chance to do it in future. :)

You were right! thank you

All OK. The M24 motor has a gear. This gear was unfixed. I've just used my screw-driver and nothing else. Thank you!

Screen 4300 (2003year) Error E5109 "Trail clamp cannot be locked PH24-1/2 or M24 is i Hello dear friends, Error E5109 "Trail clamp cannot be locked PH24-1/2 or M24 is illegal" Do you have any Ideas? Thank you very much

Dear friends, it was a pair of two cables black and brown. From 807 on the head. Thanks.

Yes! I still have this problem.. Tomorrow(on monday) technician will visit me. But I don't have big hope with this visit. My screen is an old, diodes are not new (about 7000 hours) but it used to produce good plates till this error (E7e06). Special respects for your attention! Thank you.

Hello! Need any help. Error E7e06: Expoure head error -5v power supply error. CTP stop exposing after 60% or 80%. Before I had another error: E4e04:Expoure head error. Excessive current in the LD Drive (Driver 4 board) E4e01:Expoure head error.Expoure head error Excessive current in the LD...

Thank you very much! I had replaced the belt. The Error has disappeared. There was a micro gap between the gear teeth and belt teeth. But i think i should change the servo motor soon. I heard bad sound when rotating the bearing of the servo motor.

Please, send me a service manual for Screen 4300. [email protected] thank you

I've got new error instead of. This is E4165. Mechanical error The drum is rotated to the “lead clamp position”, but the status of the Servo controller (SVC) has not changed to “Ready”

I've sent it to your private mail. thank you

Thank you. I've changed the position of servo motor , so the the belt tension became weaker. I've been working without errors for two days.

Of course, this is better than nothing. :)

Hello. Strongly need help. PT-R4300 2003 y.o.m. RCP Ver V1.32 V5.00, V5.00 Panel Ver V4.0 Head Ver 1.07 2.21 Drum does really stop, but i can hear the abnormal noise from the servo motor and get this message from time to time. What should i do? Any idea...