Search results

Hi mehdipak I sent you private message. I'm waiting your answer.

Please give me numbers of bad interlocks

Hi Gianni_S, 1. Check the "bad" interlocks for 24V on OUT wire when you push it ON. (to prove that are correct) 2. Look the two "bad" interlocks - if are both on one wire - clean up and tight up that wire on interlock board I put off the interlock pin from panel and put on into interlock...

Hi, Gianni_S Bad contacts on board. Check up interlock cable joint on interlock board and tight it up.

I tried to repair that board, that seemed weird me too. I have schematic of carr_board P00008 (older version) only. "Unfortunately" I met some unsolved questions... and reached the end in my pathetic attempts....... Please do not advise me to buy a new carr_board due to the general economic...

Hello, all do anybody remember what the encoder revealing with error message: "...X4 encoder test error..." Errors are 0048 and 0049. While booting, after picker's initializing, carriage moved some small distance and stopped with message. I was thinking that was follower encoder, but now I have...

Thank you very much!!!

Hello, all How to get in maintenance mode? need a password....

Farshad, Original DEC stores in the paper bag. Only C9 Diag Chip has changed on new DEC. How do you resolve that sht?

What? Do I look like an ...........? Nobody knows? No one weird decision?

Hi, all! Let me explain the problem. This epopee lasts near a year... At first, I have Galileo VS with broken DEC-board.... At second, unfortunately, I bought a new DEC-board that I think a Galileo VS DEC-board... Today, I know, I had mistaken (I guess, that is Avantra-like board)... After...

Volodya, I know it, but my poor English not allow me explain my problem very well. I think there are two parts of firmware that OCP-module contain... One part is And second is like BIOS that operate all of them Unidiag divides them as FLASHROM and FIRMWARE In my case unidiag wrote that both had...

Hello all! I'm actually searching for firmware OCP-module. Not a flashrom! I need a part of firmware which I can burn to chip with programmer. OCP-module doesn't answering to COM-port. Sorry for bad arguements. I hope you'll understand my poor English.