prepress s.c.
New member
Hi
I recently bought a head that supposedly worked in Lotem 400 - 750 hours. however,
I have a problem installing it. when adjusting the settings,
it shows an error - either -214 or 0 jump - nothing in between, reflectivity and rcvrgain settings - correct
with foc sensor - shows one smaller reading, both readings are variable,
but the last position is either >30000 or 0 - no intermediate stages
should we do something in software - is the laser sensor broken and does it need to be replaced?
If it needs to be replaced, what should you pay attention to?
I send greetings
Jakub
I recently bought a head that supposedly worked in Lotem 400 - 750 hours. however,
I have a problem installing it. when adjusting the settings,
it shows an error - either -214 or 0 jump - nothing in between, reflectivity and rcvrgain settings - correct
with foc sensor - shows one smaller reading, both readings are variable,
but the last position is either >30000 or 0 - no intermediate stages
should we do something in software - is the laser sensor broken and does it need to be replaced?
If it needs to be replaced, what should you pay attention to?
I send greetings
Jakub