Members

cementary's latest activity

C

cementary reacted to gordo's post in the thread A-Way with Like.

Yes, I've just upped sticks and moved from a small town to the edge of the big smoke. So, I'm now in the middle of the chaos of moving...

Jun 27, 2022
C

cementary reacted to gordo's post in the thread I've Heard with Like.

Jun 5, 2022
C

cementary replied to the thread Looking for resources for new salesperson.

Check printing united alliance former pia/gate For members they have good video library lessons

May 26, 2022
C

cementary replied to the thread Prinergy Connect 9 Rotate 1bit tif prior output.

For now I've created a rule in rba. It outputs imposed PDF to the plate size 0°, this PDF goes as input to same job, then refine as...

May 25, 2022
C

cementary replied to the thread Prinergy Connect 9 Rotate 1bit tif prior output.

If i rotate 180 - the starting point to shift along height moves to tail of the press sheet. In this case you would have to create a...

May 24, 2022
C
cementary posted the thread Prinergy Connect 9 Rotate 1bit tif prior output in Kodak Systems.

Dear Prinergy users, we've been making impositions to the press sheet size for many years. So in layout section of the final output...
May 24, 2022
C

cementary reacted to MailGuru's post in the thread People mag may end print edition... with Like.

I've seen this happen a lot, not only with publications, but, even some printshops and other businesses. A new ownership group buys a...

May 20, 2022
C

cementary reacted to Horace Ezasse's post in the thread Kodak and Preps with Like.

Thanks to everybody for their advice. We had pretty much arrived at the same conclusion: whatever business Kodak is in now, it doesn't...

May 13, 2022
C

cementary replied to the thread Kodak and Preps.

Don't know about third party, but you can always put on a Jack Sparrow's hat and sail toward your happiness if you know what I mean...

May 10, 2022
C

cementary replied to the thread Anyone using Euclidean dot and why? Sheetfed Offset.

same stuff. I've tried very hard to convince my colleagues that we need to switch from elliptical to round, but failed. Then I just...

May 6, 2022
C

cementary reacted to schenkadere's post in the thread Anyone using Euclidean dot and why? Sheetfed Offset with Like.

I found switching from euclidean to round was seamless. No noticeable difference in repeat work unless you view with a loupe, lol.

May 6, 2022

Show older items

What About Profitability?

Canon

What about Profitability?
Offset yields new advantages

Read All About It

Members

Top