Recent content by dana

we used a couple of different fountain solutions with alcohol substitutes with no problems

the Epic Delta system worked very good on a komori L28, very easy to operate. -dana

Try Epic Products Epic Products International, Inc. [ Coaters - Delta Dampening System - and more... ]

there are some products I've used and had good luck with. First, I would clean by hand all copper rollers with Prisco Copperizing Solution. Its original use is for steel rollers like on some millers. Apply with a rag, wipe off. If the rollers are really bad a little pumice and press wash...

manroland just came out with a 14x20 press the "roland 50". double diameter impressions / mark free tranverters. http://www.manroland.com/com/en/5052.htm

I've attached some cross section of both presses. This will answer your question. the 10 color is a Sm, the 6 color is a CD

when doing the strike-through varnishing, we've found that you need to run more varnish than usual. C&A coatings recommends adding 1oz of opaque white to 1pound or matte varnish

I've run a Manroland 500, nice machine.

you could also try harris-bruno, look on the left for the link Harris and Bruno International - World's Leading Manufacturer of Chambered Doctor Blade Systems!

I've had very good results with Prisco's Chrome roller cleaner for the chrome rollers. At the end of the shift just apply on the chrome rollers and leave on over night/weekend. As far as start up in the morning, engage the dampener as usual and it should clean off before dropping the forms to...

RGPW17100, I use to get our turbo clean from Pitman.

on the Komori Perfecting jackets I've used Allied Turbo Clean followed up with some press wash and had good results. APC > Manufacturer > Distributor of Pressroom Chemicals & Printing Supplies

I use to have problems with the bar for the lead edge mark the sheet, I ended up using 2 sided tesa tape. (from Prisco). Problem went away. Has anyone tryed the super blue 3 material? Seems kinda pricey.

i have a bad tale to tell you all. It all started with oil pressure problems which would shut off the press. Its was ok in the morning, as it came to second shift the problems would start. We had a tech come in and adjust the oil flow units 5,6 and coater had no drips at the top of the...

I'd give speedydry a try, I've seen it work very well and gaft has postive things to say too. SpeedyDry