Recent content by DigitalPEye

That is a lot to ask for. I think you are better off spending the 60m on a rollem rotary cutter/slitter but sorting would be more a pre press thing if its variable printing. If its sorting by size with no variable you would be limited still with I think 4 sort bins. You can run several rotary...

Oh and I use a ton of yellow toner on the felts! That by far is what reduced the sc code frequency. Also I put a piece of 5mil thick teflon tape under the blades before I screw them down. About a half inch long right where the blade starts on both ends

Exactly what i was instructed to do by my tech. Probably could have avoided the sc codes from torque overload had I taken advantage of the full tcru training when we first got the 9100 in and transitioning from 901+. Im sure they would gone over it had I not expedited the training into an hour...

I have Rcop training scheduled after Thanksgiving for our new 9210 that ive got about 120M on the counter already. The sales and service managers tell me they pulled some strings to get a specific trainer out for me which struck me a little odd. I appreciate that he was a former tech and now...

I assume they are different but I have some doubts. The number on the box is the only difference that I can tell. Spent about 5 minutes tearing apart empties and inspecting the two different bottles. Even with the part number being different I still cant say for sure because...well, Lanier/Ricoh...

I have been pounding the heck outta my 9110 since install and intend to do the same on the 9210 once the bugs are worked out of it. Almost 4 million on the counter and zero toner cap issues. Many many ITB sensor issues, stacker issues, controller disconnect, pcu drum- cl unit torque overloads...