Recent content by Equintana

The issue is in the topsetter, there is two printing machines with the same name, you must verify in nthe Topsetter panel this names

coul you send me the log file, you can found it in GUI and save it, the logfile tab is located in administracion/information area.

Ok, is posible that rotating mirror is burning, could you disconect the conector of the rotating mirror,shitch on prosetter and if you have the error 3014 during the initialization, your rotating mirror must be replaced. good luck,

where do you have the off line message, in the GUI or in Speedwat Engine (Metadimension)

In GUI wha's the error number show, error v42 is not in a heidelberg error list.

The PPF/CIP3 files are generated in the PrePress area, Do you have some RIP?, ask your provider for the respective CIP3 License. Now in the Press Rom side you have Prepress Interface only you need to verify in CP2000 if is active Instat Gate or Preset Link license to conect it in the network.

Only you need to get the license for to receive PPF files on line via network from any supply in your the CP2000 Center depend which version you have it would be Preset Link or Instant Gate, call to Heidelberg.

if you have SM 74 and Prepress Interface, you need to verify in CP2000 center is active the preset link or instant gate licence, it's necesary to transfer data on line to SM 74 from prepress interface or 3er vendors. Also you need generate PPF files in your Pre Press with ink pro if you have...

Is time to buy a medium maintenance kit from G&J, part number 10062450, its a box contain gears, bearings,...

Is time to buy a medium maintenance kit from G&J, part number 10062450, its a box contain gears, bearings,...

I don't think the problem is with the laser, most seem to be a problem of focus, could you verify if the plate is well fixed in the internal drum?

What´s the error number that you have? When the air compressor reach the minimal value 2.8 bars the air switch must be closed, if not the ctp gets an error.

The disket is CONHERK and it is loaded into the herkules, you can removed and reading in a PC

You can find a file error.txt in the diskette ofb this herkules, only you need a Pc with floppy disk drive.

You can buy in Heidelberg as spare part with the following CP.186.1403 Job Memory Card Drive with USB cableThe part number