Members

gazfocus's latest activity

G

gazfocus replied to the thread Versant 80 - banding?.

Have just tried that as well and no improvement :(

Jun 13, 2022
G

gazfocus replied to the thread Versant 80 - banding?.

I have printed 100% cyan, magenta, yellow and black sheets today and this issue is only appearing on magenta. I’ve also swapped the...

Jun 13, 2022
G

gazfocus replied to the thread Versant 80 - banding?.

It runs from leading edge to trail edge.

Jun 10, 2022
G

gazfocus replied to the thread Versant 80 - banding?.

Thanks for the suggestions. I would have to look up how to check all of that haha but will have a look tomorrow and post back :)

Jun 10, 2022
G
gazfocus posted the thread Versant 80 - banding? in Digital Printing Discussion.

I’m a Konica fan but recently bought a Versant 80 as a cheap(ish) second machine and have no idea how to troubleshoot it haha. Printing...
Jun 10, 2022
G

gazfocus replied to the thread Versant 80...All lights flashing.

I had hoped that one of the cables was loose and that it'd be a simple fix but turned out to be a dead power supply.

May 26, 2022
G

gazfocus replied to the thread Versant 80...All lights flashing.

We had the tech out yesterday and he was of the same opinion as your tech that one of the two low voltage power supplies had failed...

May 26, 2022
G

gazfocus reacted to adriansto's post in the thread Versant 80...All lights flashing with Like.

Probably touch screen panel cable connector behind the UserInterface control panel was not properly seated. Will be nice for you to have...

May 26, 2022
G

gazfocus reacted to ReproElectroProspero's post in the thread Versant 80...All lights flashing with Like.

I asked my tech while he was here working on my booklet maker what he would do if he saw all the lights flashing. He said he'd check...

May 26, 2022
G

gazfocus replied to the thread Versant 80...All lights flashing.

I left the machine overnight and did as you suggested this morning but still no joy. I've had a reply from the company I purchased the...

May 24, 2022
G

gazfocus replied to the thread Versant 80...All lights flashing.

Thanks, I shall give this a go

May 23, 2022
G

gazfocus replied to the thread Versant 80...All lights flashing.

I’ve sent them the video but was hoping it’d be something simple that I could fix to get me up and running.

May 23, 2022
G

gazfocus replied to the thread Versant 80...All lights flashing.

It is on a service contract, yes.

May 23, 2022
G

gazfocus posted the thread Versant 80...All lights flashing in Digital Printing Discussion.

Anyone with a Versant 80 experienced all the lights flashing on and off? We only had this installed on Thursday, left it over the...

May 23, 2022
G

gazfocus replied to the thread Skew on Morgana Docufold Pro.

Hi Halmac, Our plates don't have skew adjustment on them I don't think as it's all done digitally. There's a roller tilt lever which...

May 23, 2022

Show older items

What About Profitability?

Canon

What about Profitability?
Offset yields new advantages

Read All About It

Members

Top