Recent content by @gochigans

No I have the service manual, actually requested to be acquired according mailed your offer in any case not as aligning the drum, which helps you could give me on this?

dear farshad repair as the engine that moved you comment armature magnets, the paste and mounted again, however still gives me the error A0482 in some cases before the A0301 me, eh been reviewing all but really do not know what is the origin of the fault, a sensor could be moved, a communication...

dear farshad repair as the engine that moved you comment armature magnets, the paste and mounted again, however still gives me the error A0482 in some cases before the A0301 me, eh been reviewing all but really do not know what is the origin of the fault, a sensor could be moved, a communication...

Dear Farshad repair the motor armature as you discuss one of the magnets was misaligned and three more loose Now to give boot sequence I get the following error A0483 in helping the OCT not get this error in the error code. you think I should check? I tour the droll as it is to just give the...

Dear Farshad Can you please send me the catalog of parts for this equipment, to locate the collector drum motor, I think I'll have to replace it. if you have any technical information you can send me would be very grateful. the links on your page does not open any. thanks Rafael Murillo...

Hi Farshad. Without knowing what has been done prior to These error, I `d like to know: 1-Do you have errors These plates without being loaded and During the boot up sequence? If during the boot sequence, then the engine note, adjusted and made new tests, there are mounted with Plate 2-What...

Prints La Plancha, then turning the Droll not loose it and then damaged. Errors: A0012 and S1064

disassemble the engine and note that one of the magnets of the field was misaligned, so I proceeded to send it for repair. I'm checking that occurs parallel to the clamps do not release plate drum I would like to help with this error because the A0303 error listing OCT does not appear. Thank you.

Ok Thanks for the clarification My problem is this: The bar drum when being returned to release plate, sometimes it do not release clamps and a jam.

Hi I have a Xcalibur 45S and I get an error A0303, reviewing the system got two things: One of the motor field magnets was out of alignment and was loose, so disarmed and sent for repair (replacement) since it was split. Furthermore no fixed clamps then release the printed sheet, so that we...