Recent content by kazimates

On Polar 76 EM (LMS system) when we turn on device and says to backgauge to front or rear it just goes to front and the lms value comes to display. When we give a command to the go to rear it try to comes to front. If we remove the lms cable from daughter (DB9 male connector) board or on lms...

On Polar 76 Em (LMS module) I need to be sure from LMS board 6 pin circular socket to 9 pin DB9 socket connection layout. Which pin must be connected to which pin on end of the cable? What is the schema of this cable connection?

I have a Polar 76 EM and it works with a LMS (Linear Measuring System) module. I am not sure but I want to learn how it find the reference point at the turn on the machine. The device is find the reference point on LMS system is it true? If I want to make a modification on the machine what is...

Polar 76 EM is still running and when I turn on the machine it looks like ok. I give a command to the backgauge to the back or front the backgauge is running but display can't find the reference point. The display is not count any position. The TAM card has a 5V DC. What is the problem? Machine...

Dear Buntpapier, Of course we repair the machine with given instructions. It works 2 weeks periods and after that machine gives a problem on display pcb. I am still waiting the card from the United Kingdom now. For about the forbidden word of course the manufacturer or local authority can be...

I solved this problem with a EAI board replacement. But if you have rom ics and 8255 it is possible with a replacement this ics you can solve your problem. If the -12 and -30 volts already done.

yes i measure the power module on left hand side. 406, 407 and 405 ports when i read the values it looks like ok. and at the same time i changed the rectifiers which one is screewed on heat sink. the problem is still same. Kazim ATES

dear Buntpapier, thanks for your message. my email address is [email protected] best regards,

EAI board polar 76em EAI board polar 76em On the EAI board we had -30, -12, -30 and -12 volts on the test point are ok. all of the fuses on the left power pcb are ok. on eai board we had nec 8255a-5 ic, and er3400i rom ics. i want to speak on this rom ics. is it just store the paper cut...

Dear Buntpapier, Thanks for your email and forum messages.Which card is occurs this error. If you shows the correct card name to me it is possible i can check the electronic components on it. For the another spare machine i can just say no. because we don't have same barnd and model here. our...

is it trusted site? is it trusted site? Dear Ann, I read your message and thanks for your information. I want to be sure if given link is trusted site because it looks like warez site and they don't show and sample pages to us if it is correct manual/s. Can you give detailed information to...

We bought Polar 76 Em and we repair the power drive of the motor and the machine is works. But we haven't got any manual of this machine and we can't program the machine. If you share the english manual or explain to us how we can store program i- with a cutting sequence ii-without cutting...