Recent content by LoSeR1695

Hi Dan, Email done

4 Stations Stahl Brehmer Saddle Stitcher for sale, Model: ST 300/ HS 300.1 Feeder: TAS 300 Cover Feeder Folder : UFA 300 Trimmer: TR300 Machine refurbished on 2017. Please do email [email protected] for further information . Thank you.

Hi Scook, For Goss Community, set Blanket Cyl #12 to Plate Cyl #13 first, then Blanket Cyl #11 to Blanket Cyl #12, and set Plate Cyl #10 to Blanket Cyl #11 last. Make the adjustments on both the operating and drive sides of the printing unit with same procedures.

Thanks you very much for your explanation Sir, appreciate.

Thanks Al, will contact engineers from manufacturer.

Thanks Sir, I'll get some information about positive feeding and neutral feeding blanket first as I'm not really understand about it. Replacing whole 8 pcs blankets are the only things I can do now.

Dear Alois, 1) C+M+Y is ok. 2) Web is tight before entering black. 3) No, the web is going up straight to the black blankets. 4) The web was tight at the beginning, then it slowly become slack at same speed without lowering down the web tension. 5) Sorry, not understand about this questions.

To answer your questions, Everything back to normal after I put the used blanket back on. Black just getting advance and advance, it's moving the same way all the time. 1. I did not measure the thickness as I assume it is the same 1.71mm supplied by the same supplier. 2. Sorry can't understand...

Thanks very much for your info, wish you all the best

I know what is bearer, but I'm not really understand the function of it. Some of them tell me it's for iron to iron settings, some of them said iron to iron is set by cylinder surface, not the bearer, so I get confused. I am new to this industry, my boss just hire me, and hire two more...

Dear all, I'm currently facing a problem which I don't have enough experience to solve. We are using Goss Community SSC, which is only 18 months old, printing on CMYK order. When we replace 2 new blankets on black, which is the highest level of a 4 HI tower, the register of K will drift during...

Thanks very much for your info, we are currently following the lubrication schedule of the manual. My boss thinks that cleaning blankets and machine are maintenance team's job, so I had to do it,:) If you don't mind, can you please explain to me what's the function and importance of bearer...

Dear all, I'm a newbie in offset printing industry, and I'm responsible for maintenance team. As maintenance team had just been set up, there are no senior staffs guiding me. Would like to ask about what preventive maintenance should be carry out as practice rather than just cleaning blankets...