Recent content by Muhammad Hassan

Dear Friend, I am facing the problem in Agfa OLP Processor, When starts the processor boots normally then garbage data is shown on the display and Processor temperature shows 0`Degree, also shows garbage data on the display and seems that the data is resets after few seconds...

DO YOU WANT TO SALE hw-776 CARD?

Avantra 25 with Focus Jam error Avantra 25 with Focus Jam error 1, possibility of Focus motor is not working properly, (try to move manually by hand) 2, Focus jam sensor is not functional, check with agfa diag software / clean sensor. 3, CSDM board connection are loose reconnect it Regards...

I have also tried on MC and PC with viper RIP software

RIP name = Agfa PDF series 2 v 2.0 Mac or PC = I have tested on both systems PAC or UPAC APIS Card = UPAC APIS card

Agfa APIS PAC Board Agfa APIS PAC Board I have agfa APIS Card which working fine on Agfa Accuset 1000 but when I connect with Agfa Avantra 25 messege appair "failed to open APIS driver" can anyone help

Agfa APIS PAC Board Agfa APIS PAC Board I have agfa APIS Card which working fine on Agfa Accuset 1000 but when I connect with Agfa Avantra 25 messege appair "failed to open APIS driver" can anyone help

I send Postscrip file (PS) for print and some time error display that "requested page size too big" while file size is A4 and i use 18" film roll on machine

I m using Agfa PDF RIP Series 2 and facing problem when I send job Error appear after one color and some time after two or three colors. Error deatail given below. There was an error found when printing the document "Job name.qxd" to \\.\pipe\PDFRip.

We changed the SGM in machine, this problem occurs, New SGM we have testedon another machine which is OK, BUT in this machine we are faceing problemof bow which cause back to back not register in middle. we have taken out the carriage, bearings are perfectly OK

Thankyou for you detail message with inputs, There is nothing wrong with the Cover, which is properly closed and carriage moves OK There is nothing wrong with the spinner it is properly mounted, and puting image striaght on drum thats why registration is OK. Film is properly vacumed on drum...

Avantra 44S Machine, Image on drum in the Middle, is not 100% striaght itis curve(.25mm) and because of this, 4 films registration is OK, BUT whenwe put front back it is misregister in middle, while four corner are OK register.

front back registeration problem front back registeration problem Avantra 44S Machine, Image on drum in the Middle, is not 100% striaght itis curve(.25mm) and because of this, 4 films registration is OK, BUT whenwe put front back it is misregister in middle, while four corner are OKregister.

Hassan Hassan I have installed a new spinner motor and solved a problem but now i m facing a new problem that front back registration problem on output Thanks

hi, i am facing image tilt problem with my Avantra 44S, I have exposed 4 color job and check registration is ok but when I flip any color and paste it to emulsion to emulsion and check registration, from top side of job mark move about 2mm, i have checked my job scal from top and bottom are ok...