Recent content by Platenworks

Ask your diemaker to make a counter die for the scores. Or cut them in using red fiberboard. If it's short run, you could try the masking tape method above....

If you've got an interested employee, I offer operator training! I've been running Kluges for 40ish years, now I'm repairing and training operators around the country. Based in Sacramento with plenty of references.

Die cut them on a kluge. You can put a little heat in the die to assist in cutting though the laminate. Have your die maker rule the die for laminated stock.

Find someone that has a digital die cutter for the first sample. Then take that to a bindery shop that does die cutting and see if they can produce it. Get estimates from both and go from there.

Sounds like it might be a complex project. If it’s going to be die cut using a conventional steel rule die, you should get a quote for the die—it could get quite pricey. If it’s a low quantity-go one up if it’s in the millions go multiple up

Platenworks.com I’m located in Sacramento. What are you trying to run on them?

Thanks! [email protected]

Hello-trying to find a manual for our cutter. We need to erase all of the jobs programmed at once instead of going job by job. Also need to square up the back gauge. TIA