Recent content by Pratik

Thank you guys. Our engineers have told us that it is better for the ACs to reach the optimal temperature and for the machine to run a few prints before doing a calibration. So currently we run a couple of non critical short jobs every day and say after 15 odd minutes of the machine running we...

We are running a shop with 2 Versant 80s with Fiery EX80 and running about 125K prints on each one of them. We have been running both of them for about 30 months now. We tried to define the best process for calibration in terms of when to do it and how to confirm if it was successful by printing...

Not all of India, but state by state. One of the larger states - Maharashtra (where Mumbai is located), has just banned all single use plastic which includes plastic bags also because also the bags used here are extremely thin. Infact most are lesser than 50 microns. Largely, the majority are...

Hey Craig, Thanks for the reply. We are based in India and primarily doing only short runs, usually 24 pg booklets maximum. I am sure we can import staple pins into India from one of our associate trading companies that is based in the US. Can you give me an approximate cost of pins. I believe...

Hi, We are thinking of buying a preowned watkiss of the above mentioned configuration. Any feedback for this product? Any users with any tips? Positives, negatives, etc.. Also, wanted to enquire if you staple pins from some other manufacturer work on this machine, because apparently Genuine...

1. For the black density issue, I will try and send a scanned image tomorrow itself.. Also will try running at slow speeds and update you. As for 2. the engineer did come in and made some modification the assembly and it seems to work better for now. Thanks

The local konica minolta engineers have changed the drums and developers and even the charging grid. The funny thing is that this is the problem since day 1. We have printed about 180,000 prints and there is no change. Even if we print a 4 colour (CMYK) black it worsens gradually across the job...

KM C8000 black density problem KM C8000 black density problem Hi, We tried calibrating for different stocks but the situation is still the same. Anybody has a solution for this or anybody else facing similar black density issues? Thanks

Hi, We are using a C8000 with creo for about 4 months now. Overal pretty happy with the colours and speed when it runs properly. Have a couple of issues though and need to know if this is a machine problem worldwide or something messed up by the engineers who set the machine over here in India...

Could somebody tell me the difference between LD-6501 and C-6501.. I know one has the KM rip while the other has a Fiery/Creo option.. But what would be the major factors I should consider before making a choice. In India, there are two different companies (agents) selling the two different...