Recent content by Quickerprinting

Good afternoon everyone. I had to talk to tech support they had me "Turn the feeder off, hold the advance button down, turn the feeder back on. The LED should blink a number of times which will indicate the new mode. It goes from 1 blink then increases by 1 until the highest mode is 6 and it...

I have switched the wires around that did nothing. I started with the settings you sent me because I saw them in this thread and tried that last week and there was no luck. I don't understand what is going on. I am going to try emailing them with the email you sent me. thank you for all your...

Good morning I have attached a video I took of the feeder to show what is going on. I thought video would help more than pictures. I had to split in to 3 clips. any help would be great I have done everything from unplugging it from the printer and the wall nothing has changed its just stuck...

Has anyone had an issue where the rear motor on the feeder is constantly on when you turn it on? The green belts just keep moving making it so you are unable to put media on them unless you have the feeder off then when you turn it back on and it stars running and then when it gets to where the...

I wanted to thank you for this information because it was a real life saver. I had a job stop in the middle of a run and this fixed my problem this was the first time I needed a work around. Thank you for this thread.