Recent content by QwazST

Intrigued. It’s there a link or video

A few customers have had issues with the screws stripping, and another customer with the metal holder being stripped out, the part to replace is over $1000. so was just seeing what others have been experiencing.

How’s does that help with the threading stripping?

Any users out there having issues with the threading on the screw or holder that carries the blade stripping out? What have others done to remedy the problem? I have seen a 3D printed piece to help with the tool holding in placer better. The holder is soft cast metal, and we have re-tapped to...

Think I have what you need. Message me I’ll try to email.

What sheet feeder do you have? 2000 or 2200. This might help you.

The plastic casing was designed around offset printing when they came out with these machines. They did pretty well, but if they were left unattended, off, they would flat spot, causing other issues with skewing. The reason why they went to the Grey rollers was. The US market was complaining of...

Yes, I’ve rebuilt nine machines with these rollers that are updated. They’re like the old 645 rollers but a little bit different material. Should be back to 1,000,000+ lifespan.

It’s the rollers, have seen this issue in the 646 model, rollers discontinued, expecting it soon in all our 618 models out that we take care of. Rumor is a replacement roller coming for the 618 but no bulletin yet. Duplo will not do anything until a ton of complaining. They consider the soft...

Usually see this issue with Windows 10 and Windows 11. There is a driver enforcement that you need to turn off in windows 10, and in Windows 11 that driver enforcement and core isolation. Get into device manager and go to USB I believe and see if the Duplo IF is working for the driver, you still...

Correct on the distance of sheets to the exit. The sponge rollers on that model over time will wear also, spec says 1 million cut 618 I’d be shocked if you get there without having skewing issues. In the 646 model you’ll get lucky to get past 150k in some instances, so even that you have less...

Thought I would post this up here and see if there’s any techs or dealers that wondering if you can help me out with some information or possibly where to find one of these it is not in stock. Trying to help a customer out. Also would look at possibly purchasing the back half of the booklet...

Cycle through with the <^> to count push green button

I’m based out of Cedar Rapids, home office Des Moines. We cover Full state. Only two of us doing it, was just me for a few years but I just hired a new tech in 23’. We don’t have much up in the upper north west, 4 hours to get there makes for long days. We have 15 systems eastern part of state...

Have been working with on Duplo’s since early 2000’s. Just installed the new 700i at an account whole system is 40’ long 😮. I could get the one I saw going but they did not want to put any money into it. Where you located?