Recent content by Rover

The ECRM service company is Elkran International, +234 (1) 4703884: 10,Olaitan Odularu Street Off Nnobi Street, Ikate Surulere PO Box 8051 Surulere Lagos

This is usually the lazy loop drive motor belts need tightening.

I don't know if you got this sorted, but the earlier post about the input motor faulty normally gives a circa 1mm "beat" pattern - lines across the plate width. You can check this by swapping the input and output drive motors, they are identical, and the fault should move to the trailing end of...

You will be struggling to get a decent CTP and plate processor at that price, I don't count the G & J, it is way too slow for most companies. The later Highwater Cobra or Python machines would be ok, as would an ECRM Mako2, as an ECRM engineer I know these rather better. You may be able to get...

Hello, As long as your RIP is the PC variant, then you can run the Rip and the CtServer interface program on the same platform, though you MUST have two hard drives in the PC. The interface to a Mako2 is by SCSI, so you need a SCSI card in the PC, ideally an Adaptec 2930CU. ECRM now use a USB...