Recent content by Zubaz

Consult your sales rep Consult your sales rep I am assuming you haven't called your tech or Sales rep for help on this but the KM C451 should only run 300 GSM out of the bypass tray. You will also need to set that tray to thick 3 or 300 GSM, at the device and in your print driver, as it needs...

The KM C65HC is a sRGB device capable of hitting a wider color gamut which will give you more florescent like output. What you see on your monitor is what you should see on the output as opposed to your standard RGB to CMYK simulation output which can vary. If the C5501/C6501 can't hit the...

The KM C6501 is a great option to look at, there is a lot of great info on the benefits over the Xerox. I have a customer who runs a C6500 and Xerox 260 and she tells me the C6500 is a better device. The internal controller's tend to be limited in their ability to sync with color profiler...

I am hoping someone can help me out. I have a client who cuts their own paper right off the pallet and uses that paper on the C6500. It typically runs fine but occasionally will jam. Any info you can share as far as the reliability of cutting equipment or running this type of media on a...

VDP Software VDP Software Prism - Doc Form Fabsoft - Reform EFI - Electronics for Imaging - Freeform2 Darwin - Quark express just a few you could look into, hope it helps

Maybe i'm a little high on the PM time on the Xerox, as you did answer correctly in that having a good field tech really makes the difference.

From what I've heard Craig the PM on the Xerox devices takes 4 to 6+ hours as opposed to 2.5 hours for the KM 6500 (which we perform every 200k) not sure when Xerox PMs are performed..... And if you anticipate the customer having to change drums, etc themselves then how much downtime would you...

KM 5500/6500/6501e all the way KM 5500/6500/6501e all the way The tray heaters are designed to condition the paper to be more readily acceptable to the device. Temperature/humidity control is vital in most print organizations. In regard to Danka and KM Branchs they are pushing boxes in my...

Zubaz here! 26 year old male (100% Norwegian-American) I was a bagger at a grocery store in middle school, a landscaper and Target technology salesman (cameras) in High School and worked in food service and the Mail room in college. For the past 3 years I have been a consultant for a...

Two 6501's is better than one of the big boys in my biased opinion, because while completing a PM on one device (usually 2.5 hours for every 200K) the other device can be running full throttle. Not a bad deal at all when compared to the $100,000 + you may spend for one device from other...

Biased or unbiased? Biased or unbiased? I'm new to this posting thing but I'm a consultant for a local KM dealer and have a lot of respect for this marketplace and the products we compete against. The truth of the matter is that all the devices whether Xerox, Canon, or KM, have their...