Search results

You can email me at [email protected]

You can talk with Terry Allen from Spectrecom. Email me if need his infi... He is located is Los Angeles

Cant we just all get along

I have seen people do it 2 ways.. Just like you did or linerize the plate. Then apply the press curve on top of the linerized plate. This is done this way Because if you have a major shift in color you can check your linerization on plate instead of going through the process of fingerprinting...

Good Day I have a quick question for anyone familiar with the Trendsetter News with the seimens controller loader. I looked everywhere for the manual but could not locate it. My customer is trying to turn the slip sheet remover back on and I was told that its just a couple key strokes. not being...

good day Did you resolve your Curve issue in Rampage?

I Sell, Service and Buy both machines and I have to say that both are great machines as stated with the newer Trendsetters and Magnus GMCE has a service dongle. I think I am ok with it because it would insure that the person or persons touching your device are factory trained and certified.

I made a million in my Printing business.... I started with 6 million

The determination of repair just by someone looking at the screen and remarking "I havent had a single problem with the clamp. So just resetting the error is fine." when your oil light comes on in your car do you put black tape over the indicator and say "My car is ok the engine hasnt blown so...

give me a call.. The proof is way over priced. 702-684-0059

I have seen and heard a lot of complaints on the cost of the upgrades on workflows. The only thing I have to say is that the software developers have cost and have to make money just like you do. I can assure you that no one at Rampage has 2 jets a yacht and an Island in the south pacific with...

Wow...Nice. I have never seen inside... WTG. I see the GLV looks alot stronger and robust than the screen GLV. oh wait was that a tiny time bomb I see activated. BOOM. dead leave it alone and call EZ Hitech if you want it replaced

I may have some suggestions... through email

I had the same issue with a customer in southern California. I dimished the sound considerably by putting a peice of tape over the tan speaker on the control side of the device. this is very simple. send me an email and I can coach you through it... I am screen certified

In my experience with the TS Focus and Zoom are real critical. Do you know what your settings on the imager are set to? drum speed, power, focus and zoom? Ray

Cornish. Thank you for saying something about posting. I know for a fact that post are seen by thousands of people and the answers are a great help. Rob understand one thing. You have changed a batch of plates and it seems like it is solved. the batch of plates that where used doesn't...

This processor is to small. Not unless you can configure A turner to hold the exit buffer at about 3-1/2 - 4 foot. If you are Only using one thickness of plate you can turn the communications off But make sure that someone is always around when you run plated. Email me and I can give you more...

RVng The Fully auto saber would be very difficult to put a turner on it because the exit buffer has motors and sensors. This Device normally connect to the processor and has communications selecting the deifferent heat settings for the thickness of plate. The processor is normally a Heights...

I am factory certified on the Z system. If you need assistance or setting the proper conductivity please let me know.

Well the truth comes out of ourdear customer. No service contract.. No pm for 3 years and the plate Was just thrown into the thermal direct setting.... Ha Ha!!!!! Why why why..... Do it right or don't do it at all... Kevin sorry about wasting Your time.