Search results

I have CM4 working perfectly but I can't figure a bunch of things out in CM5. Why is Y Copy grayed out or how to rotate the job?

You can gain more life out of your rollers by wiping them with this.

I just took a look at the slitters. It appears that it is possible to adjust the metal plate that interrupts the homing sensor signal.

We may not see increase in prices. We may see decreases. Trump’s plan has always been to just get everyone to drop their tariffs against us, to get to a true free trade situation with no subsidy of others by America. Vietnam, India, Israel have all dropped their tariffs against us and possible...

Long edge feed, long grain is a challenge at that thin of weight. Short edge feed, long will more likely work.

It is not Xerox that requires a new support agreement, it is Fiery. The ES3000 acts like a dongle and has a license and should enable the version of Color Profile Suite that came with it. You just won't be able to upgrade to new version of CPS without a current Software Maintenance & Support...

The licenses are perpetual but you can not upgrade beyond a certain point without renewing your Software Maintenance & Support Agreement.

Not sure I am following you. I have a 645 and it only has one knife. It does have 6 slitters. Is that what you are talking about. I have not had to manually go in and adjust any of the slitters sensor breaks but I have done that in the perforator module. The metal piece that breaks the sensor...

The Iridesse uses a BTB. If you watch for to much inboard or outboard movement and make adjustments so it doesn't tear it will last beyond it usage limit. The belt does tend have a 1/4" start to tear on the inboard side which I found if I trim it off the belt will practically last forever, most...

The physical alignment of the High Cap Feeder to the print engine can affect this.

On simplex which side is it on?

Call 2nd level support. There are NVM setting for lead to trail edge alignment. And these are based on range of paper weights. I bet your machine has a from factory print out that will tell you the paper weight range and factory setting. They usually put those papers in the pocket in the front...

I have the Iridesse but I would assume the 1000i would be the same. Just pull out the 2nd BTB and below the alignment rollers towards the outboard side of the machine, you will see a sensor there that had a cam that passes through it. There is also a cam sensor on the top alignment roller on the...

Did you clean the sensor under the 2nd BTB?

Somewhere you should have a reset to factory default for Uniform Density. If print density is too high then the SIQA Density Uniformity Adjustment tool might throw an error that is why it should be reset back to factory default before running the SIQA Density Uniformity Adjustment tool.

Did you clean the underside of the print carriage? Not just the heads.

Looks like a fuzzy or something under your print head carriage. Have you tried cleaning the bottom of the carriage?

That is why I suggested updating the values for that spot color in for the output profile with Spot Pro. For what ever reason Fiery stores the spot library output values in the output profile. I always thought that was a bit strange because I have never seen any wide format RIP do that. Don't...

Look in Imageviewer to see what you output values are for that spot color, then you know what values to put in Spot Pro for your output profile in case you wanted to assign a CMYK source profile for managing other elements in the print job. But the CMYK source profile should not be affecting...

It does if you don't have proper color management.