Search results

It's already March so I hope you got your assistance! The 18141 is usually hinting that the lift bars & roller are not in proper position. Easy to check when you open up the sensors window in Mechanism Utility. Sometimes it gets coupled with a 18128 and if so, you need to check the vacuum system...

Recently acquired a slightly-used 9880 in its original carton which on the outside, appeared to be unused - or so I thought. Unpacked it and it has its ink cartridges still in it, I pulled out one and it is dated 2010. Should I replace all the ink cartridges with new before powering up?

Good, glad that is settled... I was getting more dazed and confused than usual over this thread. .

Apples & oranges? Brunswick has the Vector TX52 CTP imaging Freedom plates which clean out in warm water. Glad you got things sorted out with that interesting technique of boiling water on the rollers! Soontobeex refers to DI presses. Two different scenarios.

What is the paper stock in this situation?

which "Vector" model do you have (Vector 52, Vector TX52, Vector FL52) and which plates?

I watched the product launch presentation and enjoyed the "demo" of how CS6 could help the fashion designer lady get her products to market. Here's what I got out of it: C T P Yup. CTP. Computer. Tablet. Phone. This is where it's going. Hardly a mention of PRINT. Yikes, what's this...

How clean and steady will the power be at the new location? That was the reason to use the Synergy back then. However, the Syngergy is no longer supported by Presstek so when it goes, you're on your own. If you go without, you can refer to the attached diagram showing the power & wiring...

Given your location, you might want to consider service, support & spare parts availability with any CTP/plate solution you encounter!

Yes, do make sure that the Thumbprint program is actually on and running. It will be on the RIP computer most likely. Look for the Thumbprint icon, double click to open, click the green "go" light. Also check Edit>Preferences to make sure the input and output folders are the same i.e. usually...