Search results

So I should be running integrated for everything except metallics correct? To double check hat is with light on? Also with the cpc tronic 1console, should I be running the keys higher with sweeps lower?

Thanks for the info. A few questions.. does for example on the forms it says 3+.05. Does that mean 3 or 3 and a half. On the night latch with the air blead off , with a feeler gauge should I be getting a slight drag all the way across? Thanks

I've seen all variations of roller stripes so looking for the correct on a sm-52 4 color, no vario. 199 model. Would like to know is it best to run integrated or not? Currently running segregated because I have to run more water in integrated. Is the setting different for integrated or non

Is there 2 different type of settings for bridge roller? What are they?I find myself running everything segregated light on. If I run integrated I have to run water settings higher

How do I determine if I have the Alcolor type water system? How do u set for integrated and segregated, is it 2 diff settings? I have the CPc tronic 1 console. Thanks

When checking water roller settings what is correct procedure? Does lever stay up or down when checking water

speedmaster 52 4 color are u supposed to set both ink forms and water form to plate at same time for the final step after setting ink first, then water?

both ink and damp. So for both set in integrated? Also, what about the issue with starting out clean, then 15 or 20 shts in it tones up at lead edge then disapears? Thanks

Should they all be set including water in integrrated or segregated? also, the first 15 shts come ot clean then it starts to scum at lead edge then it slowly disappears?

3 to plate. 4 to oscillator. Form 1 only moves if I put it in integrated. Not segregated. In units 1 & 4. There is no issue.

1st ink form. White

Yes. There fine they move when press is on but not in impression in those 2 units only

On units 2 &3. If I put it in integrated light on at consule it spins on impression. In segregated light off. It won't spin in impression just at idle

Speed master 52 cpc-1 consule is it possible in consoule I mistakenly shut it off?

Ink form 1 on both units won't go on in impression. Need help!

Those setting seem quite high especially water form to plate is that correct?

Do you set the rollers including water in integrated or segregated? Also what should be the pre and post damp settings set at in the console?

4 color Speedmaster 1999. The forms to oscilator are 4. Are the forms to plate 3 or are they 1.5,2,3,3? Was told by another pressman this is settings but manual says otherwise. Also, the water pan setting where you break off the water and then slowly tighten it back [I] tighten it but the...