OkiTech
Well-known member
Guys I have beautiful plate processor. It can process Agfa Azura UV plates and mostlikely similar. I was made for Jetplate and since that system did not really work, use is minimal. I has high-tech ceramic heaters on entrance and exit that are microprocessor controlled as well as speed setting. It can process plates for up to 28 inch press - mouth opening is about 26 inches wide. It is sparkling clean inside-out, all rollers pressure released so there would not be any flat spots - basically plug it in, add you chemicals and go.. $2300 or reasonable offer takes it. Would discuss trade for PressTek / AB Dick DPM 2340 in similar condition.
JETPLATE 64P Plate Processor by FERPA GRAPHICS | eBay
JETPLATE 64P Plate Processor by FERPA GRAPHICS | eBay
Last edited:
