Recent content by aligh

  1. A

    danmate 665 from danagraf

    Hi i want manual danmate 665 processor for dotmate7500 i will appreciated if help me regards
    • aligh
    • Thread
    • Replies: 0
    • Forum: Esko
  2. A

    Neopost Service Australia

    hi what is your problem about neopost machine?i repaired inserter and franking machine regards
  3. A

    Herkules pro

    dear All for material guide after clean you have to change parameter if i remember Guide LD or LB current you can decrease or increase for adjusting it and clear error regards
  4. A

    signasetter pro

    Dear friends i need diag software for signasetter .this software released in diskette(floppy disk)and all of machine have this software in floppy disk.it would be appreciated send files by internet to my e.mail. regards
  5. A

    need help signasetter hard

    dear all i need to buy hard drive (scsi 50pin) for signasetter.it will be appreciated if help me.regards
  6. A

    PTR-4100 RH problem

    hi what is error on ld3?what is error in ld1 ?if have error on ld 1 can not work in ch1(0-7) as i remember check ld3 in laser power confirm not zero. this is good reference for each ld .it show situation of ld . regards
  7. A

    heidelberg herkules

    dear bortolinor you have to change floppy or floppy drive.eject floppy from herkules .give copy from floppy in new one.test herkules with new floppy.if problem not solved you have to change floppy drive. regards
  8. A

    dotmate 7500 help

    Dear All any body have diagram of powersupply(24v)dotmate? we have problem in powersupply (fuse burn)when switch on dotmate thank you for your help . 9
    • aligh
    • Thread
    • Replies: 1
    • Forum: Esko
  9. A

    Avalon N$: Ex11d : When the clamp is locked, some tail clamps

    hi you have to clean 3 sensor in arm .these sensors sense clamps place in load and unload. for better check in service mode sensor test as i remember ph27-1 ph27-2 ph27-3 regards
  10. A

    error platerite 4300s

    hi ali did you solve your problem? i think you are from iran. regards
  11. A

    error platerite 4300s

    Dear Ali i sent you private message did you receive it? regards
  12. A

    Error 3703

    hi this is for material guide system can you send me files on floppy drive by mail? i send my e.mail address by private message. regards
  13. A

    CTP laser problem

    hi please check vacuum unit (show 600 in expose time) and clean vacuum hole on drum 's surface . check angle of magenta and yellow in your rip.and another setting(dpi.dotahaoe.resolution) before this problem does plate setter work with this setting (70% and 600 rpm)? did you change your...
  14. A

    New harlequin rip

    hi all we have very customer that used torrent rip(high water) with herkules(Linotype imagesetter work with speed way ). very fast and reliable and best choice. 9
  15. A

    topsetter 74 model 2300

    Dear Brian i sent private message for you regards
See more

PressWise

A 30-day Fix for Managed Chaos

As any print professional knows, printing can be managed chaos. Software that solves multiple problems and provides measurable and monetizable value has a direct impact on the bottom-line.

“We reduced order entry costs by about 40%.” Significant savings in a shop that turns about 500 jobs a month.

Learn how…….

 
Back
Top