Recent content by cgraeler

We are having some major issues with our 4 color halm jet. Last week we had to replace a harmonic drive on the first unit. After that it has been running great. Today we are having issues with color in unit 2 moving. Looks like a slur on a regular offset press, but grippers are great. I'm...

Trying to figure out what is exactly needed to connect our PECOM system on our Manroland 300 to prepress. We use XMF as our workflow. I just don't know what it needed to connect the two together to start sending CIP files.

Does anyone have any disks they can cooy or send me files from? We have a manroland 305 and cannot find the disk for the control computer. Any help or info would ve great.

It's the PIF cable. whoever had the equipment before us was not easy on the cable and tuged on it. Right now we have it in the "sweet" spot and stopped the lines, but if someone moves the cable or bumps trueflow then they will probably come back. So now were on the hunt for a new cable. Thanks...

No, there were no lines when I did this.

Here..i tried. Hope you all can see them. This is a picture of a color bar. These lines go throughout the entire image on the plate.

You can only see these fine lines under a loop. So cannot take a picture to show you guys.

I think its the data cable going from trueflow to the 4300. But that is about a $700 gamble I'm told.

We have a screen 4300 CTP setup and we are having issues with fine lines going through the job when the CTP device is "recording" the image. We have checked grounds, made sure no cables were laying over another...and cannot figure out what is causing this. Any suggestions or any ideas?