Recent content by DianneB

KM C6501 Speed KM C6501 Speed I run cover weight stocks through our C6500 on a daily basis (weights 210 gsm up to 300 gsm) both one sided and 2 sided and sizes from 8.5 x11 to 13x19. Not sure exactly how many pages per minute, but I can tell you that the machine will slow down drastically...

we are currently using fusionPro for the variable data and sending to a Command Workstation for the C6500 machine.

Okay, I am currently doing a lot of variable data jobs. I have a customer that has a cover letter with or without backer then a second page that they want nested together. I am currently doing this on our Konica C6500 color machine, this machine has a rip. I do not have a rip for the Konica...

I have been using FusionPro for our variable data work. Most of our work so far is very basic, addresses for letters with variable inside of the text part of the letter. FusionPro is very easy to master and you can create PDF's, PPML files along with a few other that we don't use. These...

Re: Canon c7000 vs KM 6500 I currently use the KM6500, I don't have any major issues with this machine except on thing. We print on different size papers a lot. We print anything from 8.5 x 11 to 13 x 19. We have had fuser issues with going from anything any bigger than 11 x 17, the fuser...

Re: konica 6500 -xerox 5000 I currently use the 6500 about 54,000 clicks per month. The only major issue I have found is when we run lots of 8.5x11 or 11x17 size paper and then go to 12x18 or 13x19 size paper, the fusing units leaves roller marks down the 12 or 13 inch side of the paper. We...

Re: Turn around times In some cases that is from the time the files hit our floor till out the door. We usually get most of our files in PDF format from most of our customers. The ones that we design for, then it is usually 24 hours from the time the files are approved. Lately we have had...

Re: Turn around times thanks, we have a scheduling system, but it doesn't seem to be working very well. I believe our biggest hold up is customer service, by the time I get the jobs they are usually 24 hour or less turns and for a lot of my jobs that's just not enough time. Di

Hello all My company is struggling with job turn around times. What is the average turn time you give your customers for jobs. We have an idea where our problem is, but because I don't work on the front end of the workflow, I wanted to get a feel for what might be an average turn time. Thanks Di

Re: FusionPRO and PPML thanks

Re: FusionPRO and PPML I would also like to know how this is done. I am new to using FusionPro and would like to know how to send PPML files to our RIP. We have a Konica-Minolta C6500 color machine with a Fiery Rip, that has VDP Resource Management. Can anyone help me. Thanks Di