Recent content by Don OReilly

I have a 4Press with a failing laser, otherwise great condition. PSM8 with TSP, cables, Presstouch, CDs + Dongles. Carnfelt GL291 with new drive motor and gear, rebuilt mother board. Make offer Bring your favorite person to beautiful Hilo, Hawaii, spend a couple days packing up what you like and...

Hello brothers and Sisters in Print, My Pantone formula guide is a 2006 version, and does not have this color listed. Could someone kindly provide the recipe? As this is the first time I've had this issue, I can't see spending the cash to update. THANKS!

thank you thank you Hi Vasyl, all the rollers have been replaced over the past 2 years. I think I need to replace the encoder at the output cassette. Do you know where they can be found? Thanks, Don

I'm having an error every time I try to expose film with the 4press "acc buffer too large" for some time, before I expose I have been using the utility to advance the film into the output cassette. there I can see values like "LDM Pls", "TKM Pls", and "CSM Pls", all running close to the same...

I have a 450 that was working great until earlier this year. Then the 5v power supply failed, I fit a new one, and it failed too, there must be a short somewhere, but the fuses look good. for $2000, I will crate the machine or remove all the parts you want. Shipping not included.

the 5v power supply on my Dolev 450 failed recently. My man Maurice of Ace Tech helped me find the fault, and sent me a replacement. Installed that, and it died again. So he sent me a second one, and the same thing happened. Now he's sent me a third, but naturally, I'm hesitant to install it...

Hello, I'm setting up a 1000 unit to print direct. The plate cylinders are about 1/8" out of circumferential alignment, to much to dial in. Can anybody tell me how to move my plate 3º or so clockwise? THANKS, Don

Data Cable Needed; TSP>Dolev 450 anybody have one?

Data Cable Needed; TSP>Dolev 450 anybody have one?

my beloved 1972 Norton Commando... good for the arteries!

Thanks PACH Besides the loose solenoid, matter how many hours I looked inside and out, up and down, I could find no bad connections or loose fitting stuff. So from within service utilities, I went SETUP>Default Setup, and then I restored the cassette parameters from the floppy, and the drawer...

Omc Omc many thanks for your reply PACH. The load drawer solenoid was loose, but after tightening it up, I'm still having the same problem. from the utility, I can "load all boards", and OMC (fast HOMC?) passes every time. any other thoughts? Don

And it also says cassette not installed, when it is! For the load drawer, I checked the proximity sensor, it all appears correct. For the cassette, I checked continuity on the plunger switch, and that is correct as well. ??????????????????? THANKS, Don

Thanks for all your help. Maurice in Ohio sent me new laser, and we're back up and running.

I'll drink to that... They won't sell me anything, unless I'm under service contract. And we're a small, mom and pop enterprise with a 4press, 2500 miles from their nearest service. I would never buy anything from them again, period.