Recent content by Nutech Shroff

Hello We have a CD102 from 2010 with CP2000 console. We do not have the license for online connectivity to take in CIP data. We now want to implement connect this machine to our prepress to take in CIP Data plus also want to implement a close loop. I have seen 3rd party softwares but I want to...

Hello Does anyone have a scanned/electronic version of the spare part manual for PM52-5P ?

Thanks - since the non coating side of the board doesn't dry easily so the main concern was marking when the boards perfects.

Thanks - Would you suggest looking for a 1/4 or a 4/1 machine? We print the 1 color on the back side of the C1S board which tends to try very slowly. The machine will be with alcolor and IR. We need to print short grain. Do you have any experience printing 1/4 or 4/1 on a SM52?

We want to print both sides of a 350 gsm board on a 1/4 perfecting press in one pass. Please can someone share their experience and the problems faced if any. We are considering buying a used Heidelberg SM/PM 52 press. Would It help to have an end of line IR?

We have Komori LP44 - Blanket to blanket perfector presses. While the machines are from the mid 90s and in good mechanical condition, we keep having problems with the eyekom system and the dampening motors. I wanted to check if anyone has successfully replaced the Eyekom system with another...

We have a Ryobi 924 machine with an online densitometer (PDS-E), We wanted to upgrade it to the the techkon spectrodrive that comes in the newer Ryobi. Does anyone know it this can be done??

We were able to solve our problem by replacing the CPU. Our machine has a PDS-E - which has to me moved by hand and hence is not very accurate. Does anyone know if we can replace it with the Techkon Spectrodrive - the one that comes on the newer models of this machine.

IT seems the computer has developed some error - we are now getting the blue screen while booting. Ryobi just says to buy the new computer from them. Can you suggest a solution.

We are unable to find the IP Address of the black box.

Yes we are able to reset and then the error goes away but then comes back again and every time the machine has to be stopped for the computer to be reset/reboot. I am trying to find a way to upgrade the computer to a new off the shelf computer.

Is it possible to buy any PC (off the shelf) and use that to run the machine. Where can one get the software from?

Hello The computer console on my Ryobi 925 has been giving run time errors and hangs up. Can anyone help me on what I can do solve this issue besides buying a new CPU from the manufacturer. Regards

Hello I have a kolbus three knife trimmer 1997 - model HD151P and the hard disk crashed last month. Can someone share a copy of the hard disk.

Which software are you using to drive the CTP thru this screen interface box