Recent content by richsweeney

What state is this in?

Is this a PDF? I could see that happening with word doc. Also, check to make sure you did not disturb anything on near the e board, like ram chips. What happens if you print it as a image?

I agree with Repro, turn off facing pages as a default setting. And report back. If you are still sending files as a .ps file, then you may want to upgrade your rip. Modern rips are optimized to rip native PDFS.

You can use indesign, a bit more steps, or montax-imposer.com, works well. $275 for one seat as a plug in. However it only works with 32bit acrobat. The is a problem with windows 11.

If you run envelopes, and don't want to open the flaps, then the xerox 180. They both do good registration, but the konica takes about 7 clicks to get your paper registered front to back.

Pocket Pal ? https://www.amazon.com/Pocket-Pal-21st-Graphic-Arts/dp/0578547015/ref=sr_1_1?keywords=pocket+pal+21st+edition+graphic+arts+book&qid=1691766706&sprefix=pocket+pal+book%2Caps%2C268&sr=8-1

Does it jam in the first 12 inches or later? We have (2) 365s and had to order the platen protector just for this reason.

photo shop is for photos

I am not a pro, but have set up our shop. First thing is get a 20 to 30 port switch. Then use shielded cat 6 cables to run to the small 5 port switches where you run machines and work stations from. Do not daisy chain. I would get one or 2 NAS devices that are backed up to the cloud or...

We have a v180 from 06.2018 and just purchased a c4080 in 10.22. No 1 gripe is 15 minutes (or longer) of voice mail hell (repeatedly having to supply SN and name, phone number) with xerox to call service, vs 0 to 15 seconds on the Konica. Sometimes I get a call from a konica rep asking if I...

check out PDF Imposition - Montax Imposer - N-UP, booklet, cut stack pdf imposition software $250 plug in, I am doing 10k cards as I write. Then be sure to use firery to send over the x-up master, so you are not ripping all day long.

Our tech in NV may have a lead, 702.561.5936 [email protected]

For 100k you get 1 4x8 board in 7 minutes 4 pass, with 4 heads, stratojet falcon. Tech support for life, will confirm in 5 years. We have had ours for 1 year so far.

After further research, it sure looks like a duplo dc 645 or 646. They do have mostly good reviews on this site. However there are many of them on ebay. I don't see that as a good sign.

I don't think you will get the register you need that way. You would need print alignment marks like you were diecuting, so the next machine could register from that. That is assuming that the material did not streach or distort in some way. The closet thing I can think of is a web offset...