Recent content by Steve_Reloaded

Thank you for your reply We want only the Suprasetter and Rip computer to be remain on in case of a power outage so that we can shutdown manually, this is just to avoid damage to the laser heads. But for this, what capacity of UPS do we need? for example 3kva or 6kva On the other hand, is 32...

Hello to all dear friends We are installing a Heidelberg Superstar 105 Scl model 2007, along with a Glunz Interpolator 85 processor, a 350 liter air compressor unit and LG 27000 split AC Please guide me how much electricity do we need and what kind of UPS and what size do we need for almost 10...

Hi Ozkan thank you i thought about Aligning of point parameters too but beside of the line the left side is little darker than middle and right side of the plate

In ctp user interface go to input and select one of material that you defiend and double klick and next next until you reach the laser power tabs and then you can change laser power Good luck

Hardness of water and spill water into develop section may cause this problem

hello dear friends hope you are fine in our prepress department when plate comes out from processor there is a line right at the intersection of left and middle lasers its very thin but shows after job printed our machine is suprasetter 105 with 3 laser heads we change the developer and major...