Recent content by tensor

Hi I get no errors displayed and the length of the job is correct except there are gaps as if the laser turns off while the capstan keeps turning. I decided to take off all the panels and unplug and replug any wiring looms I could find. I then tried a few jobs and it imaged 12 A3 pages without a...

Hi I have an Accuset 800 Plus which intermittently stops imaging resulting in clear bands across the width of the negs. When it started it only did it once in a few A3 negs, now it does it more times than not. I have jiggled all the connections to the board if it is a loose connection but...

Hi Juan I have sent payment via PayPal. It will have a different address as the PayPal is my private account. You can send it to either address I have given you. If you have a postal tracking number could you email it to [email protected] Thanks Greg

Hi Juan I'll take it for USD$450. I would prefer to pay by PayPal. If so I need your email address. I have tried previously paying by foreign bank transfer but the banks take $50 at my end and they also take at the other end so it isn't possible to work out the exact amount to send. Greg

Hi Juan Address is: Skills Publishing PO Box 514 Hazelbrook NSW 2779 Australia No longer need the Rapiline drive belt as I found a supplier locally. Greg

Drive belt found from local supplier. Greg

Hi Juan Yes I am still after it. How much are you looking for including postage to Sydney, Australia? I can pay by PayPal. Greg

I need the short cable from my APIS card on my Apogee RIP to the imagesetter cable which runs to AGFA Accuset. The one I have has had some severely bent pins, which though I have straightened gives me an intermittent signal drop out. The cable has the part number 67457-0001 REV A 16847 743 on...

I need a drive belt for a Agfa Rapiline 43-3. My one is starting to strip its teeth. To be posted to Sydney, Australia. Greg

Found the card. Now have trouble with the cable. The cable I got with my used Apogee rip had the cable plus the adaptor for the interface card. It was supposed to have come from an Accuset. When I set it up with my Accuset the imaging was coming out with jagged appearance. I changed back to the...

Hi My Hyphen rip computer got knocked out with a lightning strike and it took out the interface card as well. The rip is built around the HW776-20 card. If anyone has a HW776-20 card laying around, let me know. They are no longer available new, but I think they were used on a number of the...

Thanks Jon for the install disks. VladCanada is right, I found that Apogee won't connect to the 9400. Luckily I've just picked up an Accuset cheap. Seems nuts that I can connect a Harlequin or Studiorip to the 9400, but Agfa's own rip doesn't support it. Thanks all.

Hi I do a couple of jobs a week on the side for a local printer. We no longer produce film for in-house needs but as long as my Proset 9400 keeps going I may as well make money out of it. I've just picked up a S2 V2 after my Hyphen RIP died. There was no way I could justify the cost of a new...