Recent content by walks_in2_trees

Re: Film has too Low Density just a note about densitometers... there are several types, and there is one type designed specifically for film. So running out to the pressroom to borrow theirs is not likely to work properly if that's what you did. The idea here is to test the film, which ever...

Re: Film has too Low Density Ok so what is remaining that you have not tested for...? bad film, bad imaging device try exposing 2 rectangles, one black, the other white with a 50% border, this should tell you if the film is OK, preferably this should be done manually, to remove the imagesetter...

Re: Solid workflow solution needed. At the company I used to work for, we trialed Fugi products for about 6 months, when they couldn't get their plates to the press clean we told 'em to take out the trash and went back to Kodak. Since then I've heard a lot of good about Fugi, I think it was...

opinions and info from those who've used both I've used Prinergy 2.3, and will be working a trial period at a new job, but they use AGFA's Apogee so I'm trying to get a head start so I can clinch the deal. Links, screenshots, advice, manuals welcome all I found on AGFA's site was a sales pitch

Re: Determining Creep amount in Preps "outer" moves the outer half of the book, "inner" moves the inner half positive and negative numbers move opposite directions, either towards the face or bind edge if you have numbers in both, you should try to split the difference generally you'd only use...

I'm looking for a new employer and have a possible winner on the hook. He's suggested a trial period which we have not discussed in detail yet. All of my previous experience has been with *Prinergy* so I'm looking for some info on *Apogee* to get some idea of what to expect... pros/cons...