Search results

Greg Not that I would question your ability. But have the customer check the home and away sensors. I have had where the top sensor was defective so the machine shows that the path is up and down on one side. So it will not move because it is not in a logical position. Also. Check all...

Tony can you email me [email protected]

The pro T 3 plates are the Third generation and they have came a long way....They are much better. I think Fuji has done a good job on this Product.

Armya you tha man......

experience is going to be better than the manual. There is a breaking resistor on the machine that is possibly burnt out or servo has errors that can be accessed from the service screen

Tony... DID you get that fixed?......is the red light on when you bypass the front interlock?

Good Day I am trying to assist my customer on his computers catastrophic crash. I have tried the program on 3 different boxes with on board parrallel and pci parrallel card installed. With windows xp, windows 2000 and windows 2003 server with the same luck (bad). The dongle can not be seen. On...

First...when was the last time you replaced your lamps? Even though the lamps are on the nanometer of light that is Needed may be exhausted from the lamps. Don't assume that just because you see the light that that are working. Second.... Is this happening on all jobs or jobs with heavy...

I am no expert but look and see if the print consol's hard drive is fragmented. I had an issue with this at a local newspaper.

I've seen this problem before. The device being a screen device is very susceptible do artifacts on the drums my question to you is when was the last time you get a preventative maintenance you're not getting proper vacuum. When the device was installed proper use our maintenance requires...

After going over with Paul over the Phone we have determined that the device was out of focus. for the 8 gauge plate. about 30 tack pulses. We will let you all know how it goes at the end of the week or next week

Kevin..Great answer. The customer is not seeing it with manufactered plates in the US. I am intrigued, a minor drift in plates from the US and France maybe. but there is something else that has cause the france plate to drift out of tolerance. I am thinking the problem does exist on the US plate...

Had some banding issues but the stroke was real bad...laser head had 4200 hrs on it without cleaning. not good if you choose not to perform Preventative Maint on your device.

OK a quick lesson. If you are drivng down a country highway you notice that the lanes are fairly wide. We drift left to right without going out of our lane. look at the lane as the CTP and our driving is the plate emultion..... outside our left and right lane is out of bounds but the boundry...

Email Me so I can give you some info paul...and possibly walk you through a quick inspection...The plate in question is the 8 gauge LET ME GUESS...maybe out of focus for that Gauge [email protected]

What device are you using and plate manufacture.

Thank you for your response. I removed the pdb and tested the relays. 2 where sticky. I removed them and replaced with new ones yesterday. all is good.

Hi guys. Have a small problem Emergency stop switch: On Front door lock: Unlocked Front door (1): Open Top panel - HOME side (3): Open Top panel - AWAY side (4): Open Back door (5): Open Fanbox panel (6): Open Safety override...

not hard to do...call me