Search results

We have a 9210 & a 7210 that will not hold bak up on either machine. The 9210 is only a little over 2 years old and I am not sure how old the 7210 is. We run the auto registration, manual registration and the back up is all over the place. Paper has been checked and that isn't this issue??? We...

We ran book tabs on 13 x 19 12pt C2S and the image shrank up about a 1/16 on both tabs. The tabs were heavy coverage on both sides. We have seen the shrinkage before, especially on business cards. Any input would be most appreciated.

Our 9210 started printing like the attached photo today. I have also had a loud squeeking noise in the linear roller area that has been off and on for a while now but today it was literally screaming it was so loud. The machine will not hold back up for a whole run. Our service provider ordered...

I will post an image soon to go with this discussion. Are there any settings in Fiery for Halftone Printing? When I print halftones they look bad. I can get them to print clean I get streaks and adjust and battle to get decent prints and it's a challenge. I'm concerned that there is a setting...

Same operator with Fuser Belt marking issues. When I print full coverage pages I'm getting these fine grid pattern lines that I can't get rid of. Is this as a result of running various sheets sizes on the same Fuser? I run 13x19 , 12x18 and on the external feed can vary 9.5 x 22, 12.5 x27 . So...

We are getting lines in our fusers belts and going through them so fast our service provider is telling us we may have to start paying for them. I have 3 fusers on the floor for the 9210. Techs have advised us to change the fuser for the various sheets sizes. Well our manager will not let us do...

My external tray has a problem with feeding glossy and coated paper. It will feed uncoated paper fine, but any coated paper it jams every 10- 15 sheets and gives error code j006. I cleaned it with alcohol and that helped for like 25-30 sheets and started jamming again. Any advice would be most...